M. Windmann, A. Röttger, W. Theisen

Wear mechanisms of coated steels during press hardening

Materials

In this work microstructure of Al-base coated press-hardening steel 22MnB5, austenitized at920°C, was analyzed with respect to the phase fo...

View Full Research

Ch. Escher, J. Wilzer

Tool steels for hot stamping of high strength automotive body parts

Engineering

Hot stamping of high strength automotive body parts is a key technology to fulfill safety requirementsand CO2-emmision limit values which a...

View Full Research

W. Theisen

Abrasion resistant materials on Fe-base

Materials

Abrasion is one of the four main wear mechanisms that is determined in components being in contactwith mineral goods. Typical examples of u...

Review:

The abstract provides a clear and concise introduction to the phenomenon of abrasion, positioning it as one of the primary wear mechanisms in componen...

View Full Research

M. Woydt, H. Mohrbacher

The background for the use of hartmetals and MMCs based on Niobium Carbide (NbC) as cutting tools and for wear resistant tribosystems

Materials

In this present study, the mechanical properties (strength, hardness, moduli) and the drysliding properties of stoichiometric and sub-stoic...

Review:

This paper presents a compelling investigation into the potential of Niobium Carbide (NbC), both stoichiometric and sub-stoichiometric, as a foundatio...

View Full Research

S. Nailer, T. Klein, M. Müller, S. Grasberger

Characterisation of single-crystal diamond grit for construction applications

Engineering

The last ten years have seen a step-change in the ability to position diamond particles in metalmatrixsegments for drilling and sawing appl...

Review:

This paper addresses a highly pertinent challenge in the construction and stone-processing industries: optimizing the performance of diamond-impregnat...

View Full Research

B. Denkena, D. Dahlmann, C. Teige

Design of an active fluid damping system for vibration control of disk-shaped tools

Mechanical

To meet the requirements of today´s cutting process of natural stones thin disk-shaped tools withlarge diameter are applied at high cutting...

Review:

This paper presents an innovative approach to address the prevalent issue of vibration in large-diameter, thin disk-shaped tools used in natural stone...

View Full Research

R. Bellopede, P. Marini, L. Zichella, A. Tori

Diamond wire cutting technology and workability of natural stones: validation of a new classification method (EASE R3)

Materials

In the diamond wire stone cutting process the objective is to remove a chip of material or a layer ofuniform thickness from the entire leng...

View Full Research

Hui Huang, Guoqin Huang, Hua Guo, Xipeng Xu

An experimental investigation of vibration characteristics in the diamond wire sawing of granite

Mechanical

Compared with circular and gang sawing, diamond wire sawing is a flexible machiningmode due to its special structure characteristic. The di...

Review:

This abstract presents a focused experimental investigation into the vibration characteristics encountered during the diamond wire sawing of granite,...

View Full Research

Emre Yilmazkaya, Yilmaz Ozcelik

Development of Cuttability Chart for a Marble Cutting with Monowire Cutting Machine

Engineering

Monowire block cutting machines can be used for natural stone block squaring operations and slabcutting operations from natural stone block...

Review:

This study presents a practical and relevant investigation into the optimization of monowire block cutting operations, a critical aspect for the natur...

View Full Research

Eckart Uhlmann, Marcel Manthei

Analysis of the cutting process for milling of marble and sandstone with an end mill cutter

Engineering

Research has shown that it is possible to machine natural stone materials using endmill cutters with geometrically defined cutting edges as...

View Full Research